新闻详情

如何安装使用刀型闸阀

1.各连接部位螺栓,要求均匀拧紧;

2.驱动装置的接线须按线路图进行;

3.用户在安装阀门时,必须预留阀门驱动的必要空间;

4.刀型闸阀必须定期保养,不得随意碰撞及挤压,以免影响密封。

5.安装前须检查阀门腔内和密封面等部位,不允许有污物或砂粒附着;

6.检查填料部位要求压紧,既保证填料的密封性,也要保证闸板开启灵活;

7.用户在安装阀门前,必须校对阀门型号,连接尺寸及注意介质流向,保证与阀门要求一致性;

1. the bolt joints require even tighten;

2. drive circuit diagram for the wiring required;

3. the user to install the valve, the valve driver must reserve the necessary space;

4. knife gate valve must be regularly maintained, are not free to collision and compression, so as not to affect the seal.

5. should be checked before installation and sealing surface of the valve cavity and other parts, does not allow any dirt or sand attached;

6. Check the packing requirements of pressed parts, both to ensure the tightness of packing, but also to ensure that gate open and flexible;

7. the user before installing the valve, must be calibrated valve type, connection size and flow of media attention, to ensure consistency with the requirements of the valve;

内容由上海闸阀生产厂家上海工开阀门搜集整理,转载请注明出处..

BACK
map
联系我们:
浙江省利国闸阀有限公司
电话:
0573-540473
邮箱:
saawgbdqf@engineeringliftingandsafety.com

版权所有:浙江省利国闸阀有限公司, All rights reserved

地址:浙江省嘉兴市  电话:0573-540473  邮箱: saawgbdqf@engineeringliftingandsafety.com